Technical Information

CAN High Speed transceivers are used for the CAN bus

I/O interface. An on board termination option (solder pads)

is provided for each CAN bus channel allowing to

configure on board termination and pass through mode for

the CAN bus.

The TPMC310 uses the P14 I/O connector for the CAN

bus I/O interface.

Software support (TDRV010-SW-xx) for different operating

systems is available.

 Conduction Cooled single-width 32 bit PMC module

conforming to IEEE P1386.1

 PCI 2.1 compliant interface

 3.3V and 5V PCI Signaling Voltage

 Board size: 144 mm x 74 mm

 CAN Bus Interface

• Two channel High Speed CAN interface

• Two Philips SJA1000 CAN controller

• Supports CAN specification 2.0B

• I/O interface based on TJA1050 transceiver,

channels isolated from system logic and from each other

• On board termination option for each CAN bus channel

 Operating temperature range –40°C to +85°C