Category: Eaton

Description:

The DG1-34170FB-C54C drive is a variable frequency drive from Eaton.

The DG1-34170FB-C54C drive is designed to operate at 380 to 480 volts AC.

About the DG1-34170FB-C54C

The DG1-34170FB-C54C drive is a variable frequency drive. It is designed and manufactured by Eaton Corporation.

The dimensions of the drive are 888 x 290 x 34 mm. The drive enclosure is rated IP 54 or NEMA 12.The DG1-34170FB-C54C drive supports four-quadrant operation.

Communication interfaces available on the drive include Ethernet and RS-485 serial interfaces.

Communication protocols supported by the drive include BACNet, ProfiBus, DeviceNet, Modbus, CAN, and TCP/IP protocols.

The number of digital inputs on the drive is 8. The number of digital outputs is 1. The number of analogue inputs on the drive is 2.

The number of analogue outputs is 2. The DG1-34170FB-C54C drive is designed to operate at 50 to 60 Hz at 380 to 480 volts AC (3 phase) supply voltage.

The maximum output frequency is 400 Hz and the maximum output voltage is 480 volts AC. The nominal output current is 205 amperes.

The maximum output of the secondary load is 110 kW at rated output voltage. The maximum output for linear loads is 180 kW at rated output voltage.

The minimum ambient operating temperature for the DG1-34170FB-C54C drive is -10 degrees Celsius and the maximum ambient operating temperature for the drive is 50 degrees Celsius.

There are two expansion slots on the DG1-34170FB-C54C drive. The external control voltage is 24 volts DC and the maximum current input is 250 mA.

The drive has a rack size of FS5.The drive is equipped with radio interference suppression filters, PCB protection, a multi-line graphic display, a braking chopper and a DC connection choke.

A temperature controlled fan is also provided on the drive.

Aims and purposes of this document

The purpose of this document is to provide a reference for connecting, commissioning and operating the DPM-MC2 Communication Card.

Use of the card

The DPM-MC2 card can only be used in MICRO PANEL MC2 series devices equipped with the corresponding slot.

The DPM-MC2 card is a PROFIBUS master. The development is based on the EN50170 standard.

The card can only be mounted and dismounted when the device is powered off.

Function and control indicators

Connector assignment

The plug connectors and connector assignment comply with the Profibus standard (EN50170). Only the transceiver signals and the power terminals for line termination are provided.

The power supply terminals DGND (0V, pin 5) and VP (+5V, pin 6) are only intended for powering the cable terminals (terminals) and must not be used for any other purpose. the CNTR-P signal (pin 4) is used in conjunction with a repeater.

Bus segments must be terminated at both ends.

No more than 2 bus terminals must be activated per bus segment!

At least one of the two bus terminals must be powered by the bus station!

Maintenance, repair, disposal

Maintenance

Repairs can only be carried out by the manufacturer or an authorized service center. In this case, please contact your local MICRO PANEL dealer or Micro Innovation’s technical support department.

The warranty does not apply if any modifications are made to the device that are not described in this document.

Shipping

The original packaging must be used when transporting the device.

Disposal

Memory cards that are no longer in use must be disposed of properly or returned to the manufacturer or seller for proper disposal.