Programmer Connection, Parallel

For a parallel interface (MS-DOS programmer only)

connect the programmer to the top port connector on

the Bus Transmitter Module (IC697BEM713) as shown

in Figure 1.  Consult  Reference 2 for a description of

programming functions.

Serial Port

The 15-pin D-connector provides the connection to an

RS-485 compatible serial port as shown in Figure 3.

This port provides a serial connection to a Standard

Serial COM port, or to a Work Station Interface board

installed in the programming computer.

Squeeze the rack clips on the back of the cover

with your fingers to disengage the clip from the

rack rail and pull the board firmly to remove it

from the backplane connector.

Slide the board along the card guide and remove it

from the rack.