Programmer Connection, Ethernet TCP/IP

Connecting your programmer via an Ethernet TCP/IP

network requires installation of an Ethernet Interface

module in the PLC.  This can be either the Ethernet

Controller, IC697CMM741. or Ethernet Interface (Type

2), IC697CMM742.  Before connecting your

programmer and PLC to the Ethernet TCP/IP network

you must set the IP address in the Ethernet Interface.

After setting the IP address, connect the PLC and the

programmer running Windows software to the Ethernet Interface.

For more detailed information on Ethernet TCP/IP,

refer to the TCP/IP Ethernet Communications (Type 2)

User’s Manual, and the Windows programming

manual, GFK-1295.