The IC200BEM003 module is a master module manufactured by GE Fanuc that sends and receives data on a PROFIBUS network.

It is compatible with Versamax, PROFINET and CPU 005 systems.

About IC200BEM003

The IC200BEM003 module is a Versamax master module designed by GE Fanuc.

It can easily send/receive data on a V1 PROFINET network. It supports variable data rates.

A total of 3584 bytes of input data and 3584 bytes of output data can be processed using this module.

The module has synchronised and frozen modes. dcs-sis.com This network interface module has a data rate range between 9.6 k baud and 12 M baud.

The IC200BEM003 module uses a linear bus network topology terminated at both ends. It uses shielded twisted pair cables for data and information transfer.

The network module is connected using a 9-pin D-sub connector. It is small and compact, measuring 4.3 inches wide by 2.63 inches high by 1.956 inches deep.

The Versamax IC200BEM003 module is an intelligent module with a slave status array list, slave diagnostic addresses, and other features.

It draws a total of 5 milliamps of current from a 450-volt output.The IC200BEM003 module can be configured using a software utility with a host controller and a Windows operating system.

The front of the module has LEDs that light up when there is communication activity.

The IC200BEM003 module* supports up to 125 slave devices and can be configured through software.

Network-to-frame ground isolation is rated at 250 volts AC and PROFIBUS network to backplane is rated at 1500 volts AC for 1 minute.

The module is certified to UL standards for installation in hazardous areas.

Network Interface Module

The Network Interface Module allows the VersaMax PLC to operate as a master or slave on a network.

Currently available modules support DeviceNet master or slave communication and PROFIBUS-DP slave communication. AS-i master communication is also available.