4 Isolated Analog Outputs Module

The 4 Isolated Analog Outputs module provides four analog

outputs that can be individually jumper configured for 4 to

20 mA or 1 to 5 Vdc isolated operation. Analog outputs are

electrically isolated from the CPU power system. Calibration

data for each channel is stored in an onboard EEPROM for

both current and voltage mode configurations. The 4

Isolated Analog Outputs module is available with local or

remote terminations.

Local or Remote Terminations

All analog I/O modules are available factory configured for

either local terminations that consist of two 10-point

terminal block assemblies or remote terminations that

consist of two 14-pin mass termination headers.

Terminations are pluggable and accept a maximum wire

size of 14 AWG (American Wire Gauge).

Remote terminations provide a convenient alternative to

the standard direct connect termination. Remote

terminations allow a concentration of electrical connections

from one or more controllers to be located in a single area,

such as the rear of a 19-inch cabinet. For more information

on remote terminations, refer to Product Date Sheet

CWMICRO.