Category: ControlWave

4 Isolated Analog Outputs Module

The 4 Isolated Analog Outputs module provides four analog

outputs that can be individually jumper configured for 4 to

20 mA or 1 to 5 Vdc isolated operation. Analog outputs are

electrically isolated from the CPU power system. Calibration

data for each channel is stored in an onboard EEPROM for

both current and voltage mode configurations. The 4

Isolated Analog Outputs module is available with local or

remote terminations.

Local or Remote Terminations

All analog I/O modules are available factory configured for

either local terminations that consist of two 10-point

terminal block assemblies or remote terminations that

consist of two 14-pin mass termination headers.

Terminations are pluggable and accept a maximum wire

size of 14 AWG (American Wire Gauge).

Remote terminations provide a convenient alternative to

the standard direct connect termination. Remote

terminations allow a concentration of electrical connections

from one or more controllers to be located in a single area,

such as the rear of a 19-inch cabinet. For more information

on remote terminations, refer to Product Date Sheet

CWMICRO.

8 Isolated High Common Mode

(HCM) Analog Inputs Module

The 8 Isolated High Common Mode (HCM) Analog Inputs

module provides eight differential analog inputs. Analog

inputs are individually jumper configurable as internally

sourced 4 to 20 mA non-isolated operation or externally

sourced 4 to 20 mA, 1 to 5 Vdc, or 0 to 10 Vdc isolated

operation. The analog input circuitry is electrically isolated

from the bus interface circuitry of the ControlWave Micro.

The 8 Isolated HCM Analog Inputs module is available with

local or remote terminations.

6 Analog Inputs Module

The 6 Analog Inputs module provides six analog input

channels. Analog inputs are externally sourced, single

ended, and individually jumper configurable for either 4 to

20 mA or 1 to 5 Vdc operation. Surge suppression between

each signal and ground is achieved with 30 Vdc transorbs.

The 6 Analog Inputs module is available with local or remote

terminations.

The Analog Input (AI), Analog Output (AO), and Analog

Input/Output (AI/O) modules provide the ControlWave®

Micro with the ability to monitor and control various analog

field signals. The following AI, AO, and AI/O modules are

available.

6 Analog Inputs and 2 Analog Outputs module

6 Analog Inputs module

8 Isolated Analog Inputs module

4 Isolated Analog Outputs module

All I/O modules have surge protection that meets C37.90

1978 and IEC 801-5 specifications.

6 Analog Inputs and 2 Analog

Outputs Module

The 6 Analog Inputs and 2 Analog Outputs module provides

six analog inputs and two analog outputs. Analog inputs are

externally sourced, single-ended, and individually jumper

configurable for either 4 to 20 mA or 1 to 5 Vdc operation.

Analog outputs are externally sourced (11 to 30 Vdc) and

individually jumper configurable for 4 to 20 mA or 1 to 5

Vdc. Surge suppression between each signal and ground is

achieved with 30 Vdc transorbs. The 6 Analog Inputs and 2

Analog Outputs module is available with local or remote

terminations.