Applications

The RTU component of the 560NMS34 is a managed, plug-and-play Layer 2 switch.

Provides 4 Fast Ethernet auto-negotiation with automatic MDI/X (automatic crossover detection and correction)

RJ45 ports and a two-wire SDSL port for dedicated copper. It can be used with Rack Models 560MPR01. 560MPR03. and 560SFR02.

The switch is used to distribute Ethernet within the station via the RJ45 port.

The switch is used to distribute Ethernet within the station via the RJ45 ports.The SDSL port can be used to connect to stations up to a maximum distance of 20 km (0.8 mm diameter copper cable).

If an entry in the lookup table is not refreshed by an incoming frame with a specific source address

then it is aged out for a maximum of 304 seconds.

Maximum 304 seconds (default, configurable).

For IEEE 802.1Q VLAN frames, the switch can be configured in VLAN or transparent mode. In transparent mode

the switch does not change any frames or frame TAGs; in VLAN

mode, the switch can be configured to support a variety of applications, such as

trunking or access ports.

The switch will support quality of service if it uses an IEEE 802.1p-compliant frame format.

The switch can support quality of service if the frame format is IEEE 802.1p compliant. The switch can divide frames

into up to four queues, which can be configured as priority queues or weighted fair queues.

The switch uses a 5 V supply voltage, which can be set as the internal RTU power supply or via a jumper.

It can be set to internal RTU power or external power via jumpers.

The components themselves, the Ethernet ports, as well as the SDSL

connections and RS232 interfaces are hot-swappable.

Use the 560NMS24 unit as a repeater for longer distance transmission.